What Is a One-Rep Max?
The deadlift max calculator estimates your one-rep deadlift from a hard sub-maximal set. Deadlift singles recover slowly — a heavy pull can cost you days of training — which is exactly why estimators were built. A set of five at 80% tells you nearly as much as a true single.
How the calculator works
You enter the heaviest weight you can lift for a clean set of 1–20 reps. The calculator runs three published formulas — Epley (weight × (1 + reps/30)), Brzycki (weight × 36/(37 − reps)) and Lombardi (weight × reps^0.10) — and averages them. Below the estimate you get a full training-percentage table from 50% to 95% with the typical rep target at each load.
Common use cases
- Setting training loads for 5/3/1, Texas Method or any percentage-based programme
- Testing progress without grinding out a true single
- Comparing strength across bodyweights with a training partner
- Planning peaking blocks around 90–95% loads
Formula & accuracy
All three formulas agree within a few percent below about 10 reps; above 10 reps estimates drift high because fatigue, not strength, starts limiting the set. For best results use a set of 3–6 reps at a weight you could not lift more than once more.
Conventional and sumo estimates track closely at the same strength level; enter whichever style you compete in.
Safety notes
Estimated maxes are not invitations to test a true single. Keep a spotter, warm up progressively, and leave one rep in reserve on heavy working sets.
Frequently Asked Questions
How accurate is a calculated one-rep max?
Within 2–5% of a tested 1RM when you use a hard set of 3–6 reps. Sets above 10 reps overestimate because muscular endurance becomes the limiter.
Which formula should I trust?
The calculator averages Epley, Brzycki and Lombardi. Epley is the most widely used; Brzycki tends to read slightly lower at higher rep counts.
How often should I retest?
Every 4–8 weeks is plenty for a working estimate — retesting too often adds fatigue without information.
Should I use a belt for my estimate set?
Use whatever setup you train with consistently. Belted and belted-less sets can differ by 5–10%.
Privacy & Your Data
StatPlay runs entirely in your browser. The numbers you enter never leave your device — there is no server, no account and no upload. We store only a single local preference flag when you dismiss the cookie notice.